Nomex parts in self-adhesive version.

Self-adhesive Nomex parts

In many areas of the electrical and electronics industry, stamped and molded parts made of Nomex® aramid paper manufactured by DuPont are used in grades 410, 411 and 414. Nomex® is a product of DuPont. This aramid paper film is a high temperature resistant insulation product with an excellent balance...

Read more...
408A/408B - Rubber Renue

Refreshing rubber with MG Chemicals 408A – Rubber Renue

Seals and gaskets are important components in various applications. In our article Gaskets: important components we have written a lot about different gasket materials. Our explanations referred mainly to new gaskets. However, many people know the problem: the window seal or the door seal of the house becomes porous over time....

Read more...
Thermal management for LED – Applications

thermal paste vs. thermal pads

Thermal paste vs. thermal pad Differences of thermal pads vs. thermal paste Thermal interface materials are undoubtedly a very critical aspect of electronic component design.  They can very well make the difference between a working product and a faulty product. The purpose of thermal pads and thermal paste is to provide a...

Read more...
EPDM vs NBR

NBR vs. EPDM

NBR vs. EPDM: What is the difference?   Synthetic rubber comes in nearly a dozen major types with different properties for different applications. Two common synthetic rubber compounds are known as EPDM and nitrile rubber. The major differences between these two rubber products are their resistance to petroleum-based fuels and lubricants...

Read more...
PFA PTFE film foil

PTFE vs. PEEK

High-performance plastics are characterized primarily by their temperature resistance, but also by their mechanical properties. They are often chosen for applications that require good chemical resistance, performance at high temperatures, low coefficient of friction and high strength. They are found in many demanding applications in a variety of industries including oil...

Read more...
3M 2480 Stanzteile die cut

Silicon adhesives vs. acrylic adhesives

Silicone and acrylic adhesives are those adhesives most commonly used in polyimide tapes. Polyimide adhesive tapes consist of two layers: the polyimide film and the adhesive that is applied to this film. Although silicone adhesives are most commonly used for the adhesive layer, many applications require the tape to have...

Read more...
MG Chemicals

Acrylic Conductive Paints

These conductive coatings for plastic are 1-part solvent-based acrylic systems that are easy to apply and dry quickly. They are smooth, durable, and especially formulated for adhesion to plastics commonly used in PCB enclosures such as ABS, PVC, nylon and polycarbonate. These liquid coatings are also available in aerosol spray...

Read more...
EPDM vs NBR

Silicone vs. FKM

Silicone vs. FKM - What are the differences? Silicone and FKM compete in many applications. This article examines the properties of silicone rubber and how it compares to fluororubber, an elastomer based on fluororubber (FKM). Although silicone and fluororubber are quite similar in properties, the fluorine groups (trifluoropropyl) provide significant differences...

Read more...
EPDM vs NBR

NBR vs. FKM

NBR vs. FKM - What is the difference? This article explains the main differences between NBR and FKM, two of the most commonly used sealing materials. Both materials are a good choice for general industrial use, they offer excellent resistance to compression set and have a wide range of applications...

Read more...

Silicone, a material with outstanding properties

For decades, silicone has been a material that has led more and more engineers and technicians to create innovative solutions for medium and high voltage electrical products. Silicone has gained market share over comparable raw materials. For the low, medium and high voltage manufacturing industry, Dr. Dietrich Müller GmbH...

Read more...