Nomex parts in self-adhesive version.

Flatbed die cutting vs. rotary die cutting

Differences between flatbed die cutting and rotary die cutting Die cutting is a popular manufacturing process used to quickly and effectively cut parts from electrical insulation materials, thermal conductive products, engineered films and gaskets. Commonly, die cutting is associated with materials such as rubber, plastic, foam, paper and even cardboard. There...

Read more...
Digital-Fabricator - Dr. Dietrich Müller GmbH

die cutting vs. water jet cutting

die cutting vs. waterjet cutting Today, there are more cutting methods than ever before. While sawing was once the primary option for cutting industrial materials, today there are nearly a dozen viable options. To ensure project accuracy, efficiency and cost-effectiveness, any cutting method intended for a particular part should play an...

Read more...
Battery insulation

Battery market grows

The German battery market grew by a total of 35 percent in 2020 to 5.9 billion euros, accelerating its growth compared with 2019. Lithium-ion batteries accounted for the largest share of the market at 3 billion euros. The segment grew by 63 percent year-on-year. The market volume for lithium-ion batteries...

Read more...
ultem-1000-polyetherimid-3d-druck-folie-abm-und-farbe-waehlbar

thin and thinnest technical films

In our daily work we are confronted again and again with the question, which thin and thinnest films we have in our delivery program. Delivery program of thin and thinnest technical foils and films As you know, we supply a wide range of technical films for various technical applications in electrical...

Read more...
PEEK adhesive tape

14 Advantages of PEEK

PEEK (polyetherketone) high performance polymer films offer a unique combination of properties including high temperature performance, chemical, hydrolysis and wear resistance, electrical performance and mechanical properties. The composition and inherent purity of the polymers result in low ionic extractables, low outgassing, and extremely low smoke and toxic gas emissions....

Read more...
Battery insulation

Thermal management for rechargeable li-ion batteries

Thermal management for rechargeable Li-ion batteries The rapid growth of the electric vehicle market (such as electric cars, electric buses and electric trucks) has led to ever-increasing demands on the efficiency and lifetime of lithium-ion battery systems. Only when vehicle ranges increase significantly will acceptance increase significantly. The performance of lithium-ion batteries...

Read more...
Dr. Dietrich Müller: Punched parts made ​​of 3M VHB Tapes

Punched parts made ​​of 3M VHB Tapes

As well as a range of punched and moulded parts made from non-adhesive materials, such as Nomex®, Mylar®, Hostaphan® and Pertinax®, Dr. Dietrich Müller GmbH (Ahlhorn) also manufactures punched parts with adhesive materials. They consist of a converter 3M VHB adhesive tape. The 3M VHB tapes are high-performance adhesive tapes,...

Read more...
gap filler vs gap pad

8 ready-made thermal management solutions

In the automotive industry and medical technology, there are ever greater challenges in the field of electronics. The heat to be dissipated poses ever-increasing tasks. In this article we present 8 ready-made thermal management solutions: Standard thermal conductive foils Thermally conductive pads Thermally conductive pastes Phase change materials thermally conductive...

Read more...