Foams

Stamped parts from foams

Stamped parts can be found in practically every household in our modern life. You are certainly familiar with the protective foil with which your smartphone was delivered. Or even the patch from medical technology that has been punched. Even in the washing machine you will find polyester films that protect against water.
Dr. Dietrich Müller GmbH also processes foams into punched parts. Foams that are then used in the packaging sector to protect electronic devices, as a seal or closure.
Die-cut parts are omnipresent companions in our daily life. Whenever manufacturers have to think about how different materials can be joined together, when sensitive surfaces have to be covered or heat has to be dissipated, and when it is necessary to install precisely fitting insulation in electrical devices, then stamped parts can be used.

Stamped parts help to simplify these applications during production. Stamped parts can make an important contribution to reducing assembly time by always using the same dosage and fitting accurately.

Expert for stamped parts

Dr. Dietrich Müller GmbH is known as an expert for stamped parts made of more than 1000 different flexible materials. Whether small quantities or runs of several million pieces, the lifting and rotary die-cutting machines of the Dr. Dietrich Müller GmbH machine park ensure economical production.

Delivery forms of punched parts from foams

The delivery of the punched parts can be done in different ways: As a loose single part, as magazine-loaded single parts or also as a self-adhesive single part or non-adhesive roll. Also non-adhesive single parts can be bulked.

As a customer of Dr. Dietrich Müller GmbH, you always have a competent contact person at your side for die-cutting foams. You will also receive the desired support for questions regarding product selection.

If you need a special material that has not yet been developed, it is often feasible to find the desired solution by using the appropriate combination of coating and film. Dr. Dietrich Müller GmbH offers the complete vertical range of manufacture from material procurement, cutting and coating to punching.

An optimal solution to logistical and technical challenges is guaranteed by the optimized delivery of stamped parts and competent advice to the customer in application technology.
Stamped parts are used in many branches of industry, from medical technology, the electrical and electronics industry to the automotive industry.

Adhesives and release papers for foams

Dr. Dietrich Müller GmbH not only helps you to find the best foam or sponge rubber material for your die-cutting application, we can also help you to find the right adhesive and release paper, procure the materials and laminate, cut and die-cut the composite material for each of the foams we cut in-house.

0
Materials
0
Machines
0
Production Workers
0
Parts Supplied